01 HEAT Using a hair dryer on medium heat, warm the rear third of the frame - two inches away from the arm - for 15 seconds. Do not exceed 25 seconds.
02 TAILOR Immediately after heating, hold one arm of the frame with both hands and use your forefinger and thumb to apply pressure to the end of the arm. Bend the end down for a closer fit, in for a tighter fit, and up for a looser fit.
03 REPEAT Not perfect yet? Don’t worry! Repeat the steps again - heat then tailor until desired comfort level is achieved.
04 REST Place frames upside down - arms facing upward - on a flat surface and allow them to cool for up to five minutes.
Perform all customization at your own risk. KREWE shall not be responsible for any personal injury or property damage caused by any attempt to customize your eyewear.